Article

You are Here: Archived Articles and Videos » Woodwinds » Oboes » Oboe Articulation at a Glance

Share with:

©Christa Garvey, 2012

 

Oboe Articulation at a Glance

 

The action of articulation is a collaboration of the air, tongue, and the reed.

To create the basic process of beginning a note from silence:

1. Breathe and form the embouchure around the tip of the reed

2. Place the tongue on the reed

3. Begin blowing

4. Remove the tongue from the reed

5. Replace the tongue on the reed to repeat the process

 

Strive for perfect beginnings of notes without “dirt” in the sound. Each note should have

a distinct attack, duration, and release.

 

Articulation is created by withdrawing the tongue from the reed--not from the tongue

touching the reed. When the tongue is on the reed, the reed is incapable of vibrating and thus produces no sound. This was somewhat revelatory to me when I figured this out, because as a beginner I thought that the tongue on the reed was what created the

beginning of sound. My thinking was all backwards!

 

What part of the tongue is used?

For the most part, the top of the tongue just behind the tip of the tongue touches the reed. Only a tiny portion of the tongue is needed to touch the reed! Students often use too much of their tongue to touch the reed, creating loud, heavy sounding articulations.

I have never heard a student use too little a portion of their tongue to touch the reed.

Because of this, I teach my students that only one taste bud is needed to create an

articulation. It’s impossible to use only one taste bud, of course, but it is a helpful

visualization. 

 

Where should the tongue touch the reed?

The tongue usually touches the underside of the reed, very near the tip, but not the actual reed opening. One exercise is to have your student visualize using only one taste bud to touch the very corner of one tip of the reed. This can be helpful to produce even, light articulations. In all cases, the tongue should touch the reed to create articulations. A habit that I would discourage is when the student touches their hard palate (just above the back of their top front teeth) instead of the reed. This can create a “popping” sound to articulations and isn’t always accurate. Note that this can be a very hard habit to break and necessitates careful listening and observation from the teacher to make sure the student is touching the reed.

 

How to end a note into silence.

This is especially important and usually not taught! When ending a note, the tongue

only needs to go on the reed to create the next articulation. If there is a silence after the

note, end the note with the air, THEN put the tongue on the reed. Do NOT end the note

with the tongue--otherwise, the sound that comes out is tuT, tuT, tuT. Unfortunately this

sound is ubiquitous in beginning band programs! Sigh. The same careful attention that is used to learn how to initiate a sound from silence must be taken to learn how to bring a note into silence.

 

Below is a good exercise to develop an ear for both beginning and ending articulations. It should sound like: tah tah tah tah

 

NOT: tuT tuT tuT tuT

 

 

That's the very basics. Enough to get a beginning player on the right track, but not too

much to overwhelm in the first go.

 

Share with: